6mm Supportless Mechs - Hammer & Pincer

The Republic's long-range devastator, designation "Hammer", comes paired up with their mass-produced glass cannon, designation "Pincer". Supportless and easy to print on FDM, these 6mm mech print in just 2 pieces! The design is split at the waist so you even get a nice little waist swivel to vary poses between mechs. The bottom usually prints very easily but the top requires good bed adhesion so maybe add a little hairspray, glue stick, or brim if you're concerned about it sticking. "Most troops are lucky if they see an Anvil, Hammer, or Pincer by it's lonesome. Where things truly get terrifying is seeing them strike together in deadly concert."